Профилегибочная машина F50 для воздуховодов

Profile

Workflow

Basic Configuration

I. Electric Decoiler

● Bore diameter 460~520mm 

● Material width 200mm

● Load weight 1000kg

● Quantity: One.

● Manual Expansion

● No power transmission,with brakes.

II. Forming machine(5)

● Applicable materials:Galvanized sheet metal

● Material thickness: 1.5mm

● Main motor power: 11kw

● Molding speed: 1-3m/min

● Number of molding groups: 18 groups+5 groups straightening

● Shaft diameter and material: ¢ 48mm, 45# steel

● Great wall type plywood: plate thickness 30mm

● Transmission: Chain & gear transmission.

●  Control system: PLC control

●  Machine net weight: about 3 tons 

●  Voltage: 380V/ 3phase/ 50 Hz

●  Dimensions of molding machine: approx. L*W*H 6m*0.8m*1.2m

●  Forming roll material: Cr12MoV

●  Punching die, cutting die material: Cr12MoV heat treatment HRC60-62℃.

Basic Configuration

V. Cutting off parts(1)

● With a set of hydraulic system device

● Hydraulic motor 7.5KW, one station oil cylinder

● With 1 set of flange hole molds, 2 sets of spigot hole molds, 1 set of 45-degree cut-off molds

● Mold material: CR12MOV

● Processing hardness HRC60°-62°.

● Adopt online encoder to detect the stopping and cutting.

VI. Run out table

● Flat length 1 meters

● Flat table structure using square tube angle iron composition.

Basic Configuration

VII. PLC computer control cabinet(3)

●   Voltage: 380 V, 50 Hz, 3Phase

●   Panasonic PLC, human-machine interface control, domestic inverter speed control.

●   Main electrical parts adopt Schneider and Shihlin products.

●   The length of the encoder using the internal control encoder counting method

●   Electronic control box adopts fully sealed ventilation cooling device.

●   Control system power supply using overload protection, electronic control frame using aviation plug connection

●   Stopping cut-off mode